Configuring The Dlsw Operation - HP 5920 Configuration Manual

Step
5. Specify the destination port of
voice packets.
6. Specify the codec type.
7. Specify the advantage factor
for calculating MOS and
ICPIF values.
8. (Optional.) Specify the source
IP address of voice packets.
9. (Optional.) Specify the source
port number of voice packets.
10. (Optional.) Specify the
payload size in each voice
packet.
11. (Optional.) Specify the string
to be filled in the payload of
each voice packet.
12. Specify the number of voice
packets to be sent in a voice
probe.
13. Specify the interval for
sending voice packets.
14. Specify how long the NQA
client waits for a response
from the server before it
regards the response times
out.
NOTE:
Use the display nqa result command or the display nqa statistics command to verify the most recent result
of the voice operation. The display nqa history command does not display the voice operation results or
statistics.

Configuring the DLSw operation

The DLSw operation measures the response time of a DLSw device.
Command
destination port port-number
codec-type { g711a | g711u |
g729a }
advantage-factor factor
source ip ip-address
source port port-number
data-size size
data-fill string
probe packet-number
packet-number
probe packet-interval
packet-interval
probe packet-timeout
packet-timeout
132
Remarks
By default, no destination port
number is configured.
The destination port must be the same
as that of the listening service on the
NQA server.
By default, the codec type is G.711
A-law.
By default, the advantage factor is 0.
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no
voice packets can be sent out.
By default, no source port number is
specified.
By default, the voice packet size
depends on the codec type. The
default packet size is 172 bytes for
G.711A-law and G.711 μ-law codec
type, and 32 bytes for G.729 A-law
codec type.
The default setting is the hexadecimal
number
00010203040506070809.
The default setting is 1000.
The default setting is 20 milliseconds.
The default setting is 5000
milliseconds.