HP 5920 Configuration Manual page 40

Figure 9 Network diagram
Configuration procedure
1. Set the IP address for each interface as shown in
2. Configure Device A:
# Enable the NTP service.
<DeviceA> system-view
[DeviceA] ntp-service enable
# Specify the local clock as the reference source, with the stratum level 2.
[DeviceA] ntp-service refclock-master 2
3. Configure Device B:
# Enable the NTP service.
<DeviceB> system-view
[DeviceB] ntp-service enable
# Specify Device A as the NTP server of Device B so that Device B is synchronized to Device A.
[DeviceB] ntp-service unicast-server 1.0.1.11
Verify the configuration:
4.
# Display the NTP status of Device B after clock synchronization.
[DeviceB] display ntp-service status
Clock status: synchronized
Clock stratum: 3
System peer: 1.0.1.11
Local mode: client
Reference clock ID: 1.0.1.11
Leap indicator: 00
Clock jitter: 0.000977 s
Stability: 0.000 pps
Clock precision: 2^-10
Root delay: 0.00383 ms
Root dispersion: 16.26572 ms
Reference time: d0c6033f.b9923965
The output shows that Device B has been synchronized to Device A, the clock stratum level of
Device B is 3, and that of Device A is 2.
# Display IPv4 NTP association information for Device B.
[DeviceB] display ntp-service sessions
********************************************************************************
[12345]1.0.1.11
Notes: 1 source(master), 2 source(peer), 3 selected, 4 candidate, 5 configured.
Total sessions : 1
The output shows that an association has been set up between Device B and Device A.
source reference
127.127.1.0
Figure 9. (Details not shown.)
Wed, Dec 29 2010 18:58:07.724
stra reach poll
2 1
30
now offset delay disper
64 15 -4.0 0.0038 16.262