HP 5920 Configuration Manual page 190

A mirroring group must contain only one monitor port, and a monitor port can belong to only one
•
mirroring group.
To configure the monitor port for a remote destination group in system view:
Step
1. Enter system view.
2. Configure the monitor port for
the specified remote
destination group.
To configure the monitor port for a remote destination group in interface view:
Step
1. Enter system view.
2. Enter interface view.
3. Configure the port as the
monitor port for the specified
remote destination group.
Configuring the remote probe VLAN for a remote destination group
You must first create a static VLAN before you configure it as a remote probe VLAN.
When you configure the remote probe VLAN for a remote destination group, follow these restrictions and
guidelines:
When a VLAN is configured as a remote probe VLAN, use the remote probe VLAN for port
•
mirroring exclusively.
Configure the same remote probe VLAN for the remote destination groups on the source and
•
destination devices.
To configure the remote probe VLAN for a remote destination group:
Step
1. Enter system view.
2. Configure the remote probe
VLAN for the specified remote
destination group.
Assigning the monitor port to the remote probe VLAN
Step
1. Enter system view.
2. Enter the interface view of the monitor port.
Command
system-view
mirroring-group group-id
monitor-port interface-type
interface-number
Command
system-view
interface interface-type
interface-number
mirroring-group group-id
monitor-port
Command
system-view
mirroring-group group-id
remote-probe vlan vlan-id
Command
system-view
interface interface-type interface-number
180
Remarks
N/A
By default, no monitor port is
configured for a remote destination
group.
Remarks
N/A
N/A
By default, a port does not act as
the monitor port for any remote
destination group.
Remarks
N/A
By default, no remote probe VLAN
is configured for a remote
destination group.