Table of Contents
Advertisement
Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Note:
Download a free copy of the electrical or hydraulic schematic by visiting www.Toro.com and searching
for your machine from the Manuals link on the home page.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Before each use or daily
Every 25 hours
Maintenance Safety
•
Before servicing or adjusting the machine, stop the
machine, shut off the engine, engage the parking
brake, remove the key, and wait for all moving
parts to stop.
•
Perform only those maintenance instructions
described in this manual. If major repairs are
ever needed or assistance is desired, contact an
authorized Toro distributor.
•
Ensure that the machine is in safe operating
condition by keeping nuts, bolts, and screws tight.
•
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.
•
Do not check or adjust the chain tension when the
vehicle engine is running.
•
Carefully release pressure from components with
stored energy.
•
Support the machine with blocks or storage stands
when working beneath it. Never rely on the
hydraulics on the vehicle to support the machine.
•
After maintaining or adjusting the machine, ensure
that all guards are installed.
Lubrication
Service Interval: Every 25 hours
The machine has 5 grease fittings that must be
lubricated with a No. 2 lithium grease.
The grease fitting locations
are: Roller shaft bearings (4) and Brush shaft bearing
(1).
Important:
Lubricate the bearings to maintain a
slight leakage between bearings and housings.
Too much grease can cause overheating.
Maintenance Procedure
• Check the operation of the safety-interlock system.
• Check the hydraulic lines and hoses.
• Lubricate the grease fittings
(Figure
21) and quantities
Note:
We do not recommend lubricating the drive
chain unless it becomes stiff because of rust. If the
chain rusts, you can lubricate it lightly with a dry-type
lubricant.
Hydraulic System Safety
•
Seek immediate medical attention if fluid is injected
into skin. Injected fluid must be surgically removed
within a few hours by a doctor.
•
Ensure that all hydraulic-fluid hoses and lines are
in good condition and all hydraulic connections
and fittings are tight before applying pressure to
the hydraulic system.
•
Keep your body and hands away from pinhole
leaks or nozzles that eject high-pressure hydraulic
fluid.
•
Use cardboard or paper to find hydraulic leaks.
•
Safely relieve all pressure in the hydraulic system
before performing any work on the hydraulic
system.
20
Figure 21
g011406
Advertisement
Table of Contents
