Removing The Full Bed - Toro Workman 07390H Operator's Manual

Figure 28
1. Bed support
3. Push the bed support onto the cylinder rod, and
ensure that the support-end tabs rest on the
end of the cylinder barrel and cylinder-rod end
(Figure 29).
Figure 29
1. Bed support
2. Cylinder barrel
4. Remove the bed support from the cylinder, and
insert it into the brackets on the back of the
ROPS panel.
Important:
Do not try to lower the bed with
the bed-safety support on the cylinder.
g026142
g009164
3. Bed

Removing the Full Bed

1. Start the engine, engage the hydraulic-lift lever,
and lower the bed until the cylinders are loose
in the slots.
2. Release the lift lever and shut off the engine.
3. Remove the lynch pins from the outer ends of
the cylinder rod clevis pins
1. Cylinder rod end
2. Bed-mounting plate
3. Clevis pin
4. Remove the clevis pins securing the cylinder rod
ends to the bed-mounting plates by pushing the
pins toward the inside
5. Remove the lynch pins and clevis pins securing
the pivot brackets to the frame channels
30).
6. Lift the bed off the machine.
CAUTION
The full bed weighs approximately 148 kg
(325 lb), so do not try to install or remove
it by yourself.
Use an overhead hoist or get the help of
2 or 3 other people.
7. Store the cylinders in the storage clips.
8. Engage the hydraulic lift-lock lever on the
machine to prevent accidental extension of the
lift cylinders.
34
(Figure 30).
Figure 30
4. Lynch pin
5. Rear slots (full bed)
6. Front slots (2/3 full bed)
(Figure 30).
g002368
(Figure