SERVICE WORK ON THE CHASSIS
Installing the fork protector
10.10
Removing the lower triple clamp
10.11
Installing the lower triple clamp
10.12
3
0 0 3
2
0 0 2
1
0 0 1
x
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
–
Install the fork legs.
B00306-10
x
–
Remove the fork legs.
–
Remove the start number plate. (
–
Remove the front fender. (
–
Remove screw
–
Remove screw
–
Take off the top triple clamp with the handlebar and set it aside.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
B00309-10
–
Remove O-ring
–
Take out the lower triple clamp with the steering stem.
–
Take out the upper steering head bearing.
B00310-10
x
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the top steering head seal
–
Slide on protective ring
800115-10
M6
M6
(
p. 34)
x
(
p. 33)
x
p. 38)
p. 38)
.
.
. Remove protective ring
p. 95)
and O-ring
.
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
.
is correctly positioned.
35
.