Programming Guide; Programming Isdn Lines; Point-To-Point System Connection (P P); Entering The System Extension Number - Siemens Hicom 100 E Service Manual

10

Programming guide

Ensure that the system unit and all necessary components/modules have been correctly
installed, the line network has been set up and the terminal devices and external lines have
been connected. Then put the system into service by simply plugging in the power plug.
The next step entails initialisation
Input sequence
A * 95 62 65 93 21
B SERVICE key
C * 95 54 72 14 45
D . . . wait
E Remove power
plug
F Plug in power plug Boot system
G . . . wait
- Enter the system number in the case of an ISDN point-to-point connection, Section 10.1.1.1.
- Enter the MSN numbers assigned by Telecom in the case of an ISDN multi-device
connection, Section 10.1.2.1.
- Enter the extension number of the main PBX in the case of a Cornet-N network, Section
10.3.1.
10.1

Programming ISDN lines

One or more STLS 2 or STLS 4 modules (for 2 or 4 ISDN basic connections) must be present
for connecting ISDN lines.
10.1.1

Point-to-point system connection (P P)

10.1.1.1

Entering the system extension number

The system extension number is to be entered without a prefix and without a console code.
Direct dialling in is not possible if the system extension number has not been programmed. The
system extension number is assigned for each route (up to SW 2.0.2 only).
A31003-K16-X001-3-7620, 07/99
Hicom 100 E Version 2.1, Service manual
Meaning
Initialisation password
(detection of available cards)
Deactivate device
Country code, UK
Country-specific default data is loaded System administration
Reset system
Boot system
Check ISDN lines
System operational
Programming guide
Programming ISDN lines
Display
System administration
Time Date
Please wait
blank
blank
Time Date
S interfaces in use
0
Time Date
10-1