Configure An Ip Acl - NETGEAR ProSafe XS728T User Manual

ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
The following table describes the information that is displayed in the MAC Binding Table.
Table 60. MAC Binding Table
Field
Interface
Direction
ACL Type
ACL ID
Sequence Number

Configure an IP ACL

An IP or IPv6 ACL consists of a set of rules that are matched sequentially against a packet.
When a packet meets the match criteria of a rule, the specified rule action (Permit or Deny) is
taken, and the additional rules are not checked for a match. You must specify the interfaces
to which an IP ACL applies, as well as whether it applies to inbound or outbound traffic.
Use the IP ACL page to add or remove IP-based ACLs.
Add an IP ACL

To add an IP ACL:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Switch on page 10.
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select Security > ACL > Advanced > IP ACL.
Description
The interface of the ACL assigned.
The selected packet filtering direction for the ACL.
The type of ACL assigned to the selected interface and direction.
The ACL name identifying the ACL assigned to the selected interface
and direction.
The sequence number signifying the order of the specified ACL relative
to other ACLs assigned to the selected interface and direction.
Manage Device Security
287
Change the Default IP Address of the