Switch Features And Default Settings - NETGEAR ProSafe XS728T User Manual

ProSAFE 28-Port and 48-Port 10-Gigabit Smart Managed Switch Models XS728T and XS748T

Switch Features and Default Settings

Table 73. Switch features and default settings
Feature
Auto negotiation/static
speed/duplex
Auto MDI/MDIX
802.3x flow control/back pressure
Port mirroring
Link aggregation groups (LAGs)
802.1D spanning tree
802.1w RSTP
802.1s spanning tree
Static 802.1Q tagging
Learning process
Storm control per each packet
type (unicast, broadcast,
multicast)
Jumbo frame
Number of queues
Port based
802.1p
DSCP
Rate limiting
802.1x
MAC ACL
IP ACL
IPv6 ACL
Sets Supported
All ports
N/A
1 (per system)
1 destination port and 8 source
ports
Model XS728T supports 12 LAGs.
Model XS748T supports 24 LAGs.
1
1
16 instances
512
Supports static and dynamic MAC
entries
All ports
All ports
8
N/A
1
1
All ports
All ports
164 (shared with IP and IPv6
ACLs)
164 (shared with MAC and IPv6
ACLs)
164 (shared with IP ACL and MAC
ACL)
Hardware Specifications and Default Settings
371
Default Setting
Auto-negotiation
Enabled
Disabled
Disabled
Preconfigured
Disabled
Enabled
Disabled
Default VLAN ID = 1
Dynamic learning is enabled by
default
Disabled
Enabled.
Maximum frame size is 10 KB
N/A
N/A
Enabled
Disabled
Disabled
Disabled
All MAC addresses allowed
All IP addresses allowed
All IP addresses allowed