Vlan Routing Configuration - NETGEAR ProSafe XS728T User Manual

ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
10. In the LAG table, click each LAG once, twice, or three times to configure one of the following
modes or reset the LAG to the default settings:
• T (Tagged). Select the LAGs on which all frames transmitted for this VLAN are
tagged. The LAGs that are selected are included in the VLAN.
• U (Untagged). Select the LAGs on which all frames transmitted for this VLAN are
untagged. The LAGs that are selected are included in the VLAN.
By default, the selection is blank, which means that the LAG is excluded from the VLAN
but can be dynamically registered (autodetected) in the VLAN through GVRP.
11. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.

VLAN Routing Configuration


To configure VLAN routing:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Switch on page 10.
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select Routing> VLAN > VLAN Routing Configuration.
6. From the VLAN ID menu, select the VLAN.
This menu displays the IDs of all VLANs that are configured on the switch.
7. In the IP Address field, enter the IP address to be configured for the VLAN routing interface.
8. In the Subnet Mask field, enter the subnet mask to be configured for the VLAN routing
interface.
Change the Default IP Address of the
Configure Routing
171