Step 4 : Setting The Base Point - Roland TrueVIS VG-640 User Manual

Step 4 : Setting the Base Point

Set the base point in order to determine the area on the loaded media in which to print (the output area). The
base point indicates the right edge of the output area. You can print without setting the base point, but setting
the output area enables you to use media without being wasteful and also to print on the targeted location.
Make this setting for each individual page. When the printing of one page finishes, the base point returns to
its default value.
M E M O
• Note that the left and right positions are not restored to their defaults for test patterns.
• If you are using the media take-up system (sold separately), do not press [ ] after you finish setting up
the media. Pressing [ ] will cause the machine to make an emergency stop in order to protect the motor.
Procedure
A
Press [ ], [ ], [ ], or [ ] to move the center of the blade to the position that you want
to set as the base point.
Only the cutting carriage moves.
Base point
(right edge of the
output area)
B
When the location is set, press [FUNCTION].
The screen shown below appears.
FUNCTION
BASE POINT
Media feed direction
Output area
Print-head carriage movement direction
Output area
Basic Printing Method
Base point
(right edge of the output area)
2
53