Setting The Base Point - Roland CAMM PRO PC-60 User Manual

7 Setting the Base Point

The BASE POINT key is used to set the base point for printing or cutting.
The base point can be set anywhere you like on the material, making it possible to print or cut unused portions of the material.
The base point can be set after finishing material setup (and lowering the sheet loading lever).
The base point setting remains in effect until the setup is canceled (by raising the sheet loading lever), page feed is performed, or a new
base point is set.
1
Open the front cover and move the carriage to a new base point for printing or
cutting. The BASE POINT setting can be only when in the printing or cutting
area. Take care to ensure that the front edge of the sheet does not come loose
from the front sensor.
< Example >
NEW BASE POINT
* If the base point has been
moved, enter the value for W in
the figure at right as the sheet
size width for the driver.
If this value is not corrected,
output results may be cut off
before reaching their normal end.
The center of
the blade
mounted on
the cutting
carriage is set
as the origin
point.
H
W
Enter this value
7 Setting the Base Point
2
With the front cover
remaining open, press
the BASE POINT key.
The BASE POINT LED
lights up
Rear
Front
NEW BASE POINT
31