Roland TrueVIS VG-640 User Manual page 47

C
Peel off the two cut shapes (a circle and a square).
D
<Two shapes are peeled off together/backing paper is also cut>
Press [ ] to select "YES."
CONTINUE ADJ.?
[YES] DONE
<Two shapes are peeled off separately>
Press [ ] to select "DONE."
CONTINUE ADJ.?
YES [DONE]
E
Press [ENTER] to confirm your entry.
If you select "YES," proceed to the next procedure.
If you select "DONE," proceed to step
F
Press [ ] or [ ] to adjust the blade force.
If the two shapes are peeled off together  increase the blade force.
If the backing paper is also cut  reduce the blade force.
CUT FORCE
50gf 60gf
G
Press [ENTER] to confirm your entry.
The test pattern is cut again. Check the result.
H
<Two shapes are peeled off together/backing paper is also cut>
Press [ ] to select "YES."
REDO ADJ.?
[YES] DONE
<Two shapes are peeled off separately>
Press [ ] to select "DONE."
REDO ADJ.?
YES [DONE]
I
Press [ENTER] to confirm your entry.
If you select "YES," the test pattern is cut again. Go back to step
If you select "DONE," proceed to step
8
.
9
.
Basic Printing Method
F and perform the setting again.
2
45