About The Cutting Area; Setting The Origin Point - , , , , And Origin Set Keys - Roland CAMM-1 PNC-950 User Manual

• About the Cutting Area

Movable Pinch Roller (Left)
About 15 mm (about 9/16")
* The arrows in the figure indicating
the X and Y directions indicate
respectively the positive directions
of the X axis and Y axis when the
Rotate function is off.
When use the sheet guide
Maximum cutting area: 558 mm (21-15/16") (horizontal direction) x 24,998 mm (984-1/8") (vertical direction)
4-5 Setting the Origin Point —
The PNC-950 allows the origin point (0,0) to be set at any position in the cutting area.
When loading a rolled sheet set DIP switch SW-9 to OFF. Once the sheet is loaded and the SETUP key has been pressed,
the origin (0,0) is automatically set to a position near the left movable pinch roller on the left-hand side. When the
ROTATE key has been pressed to turn on the Rotate function and make the ROTATE LED light up, the origin is set to a
position near the movable pinch roller on the right-hand side.
When loading a flat sheet DIP switch SW-9 should be ON. Once the sheet is loaded and the SETUP key has been
pressed, the unit will scan and calculate the sheet's size, the origin (0,0) will be automatically set to the sheet's front left
edge.
If there is no need to move the origin initially set, then it is not necessary to make the origin point setting immediately
after loading a sheet.
You can also set the origin to an uncut area of a sheet in order to use the sheet with maximum effectiveness.
Procedure
* If a sheet has not yet been loaded, then before setting the origin point, refer to "Loading the Sheet" on page
7 to load the sheet correctly. Loading a sheet after the origin has been set (by pressing the SETUP key to
extinguish the SETUP LED) cancels the origin that has been set.
(1) Use the , , , and
carriage to the position on the sheet where the origin
point is to be set.
12
Cutting area
About 1 mm (about 0.04")
,
keys to move the tool
584 mm (22-15/16")
Cutting coordinate Movable Pinch Roller (Right)
origin (0,0)
, , , ORIGIN SET Keys
(2) Press the ORIGIN SET key.
ORIGIN SET
24,998 mm
(984-1/8")
→
The SETUP LED flashes once
The origin point has been set