How To Print And Cut With Crop Marks - Roland TrueVIS VG-640 User Manual

Printing and Cutting with Crop Marks

How to Print and Cut with Crop Marks

1.
Print with crop marks.
A
Use your software RIP to configure the settings to print with crop marks.
For information on how to make the setting, refer to the documentation for the software RIP you're
2
using.
M E M O
When printing with crop marks, a margin to use in detecting the crop marks is required. Set the
margins according to the figure shown below. You can set the margin value with the software RIP
you're using.
1.5 mm
(about 0.06 in.)
I m p o rt a n t
Alignment marks and symbols drawn using a graphics program cannot be used as crop marks.
B
Prepare to print, and then send the printing data from the computer.
" P. 28, "Basic Printing Method"
The crop marks are printed as shown in the figure.
Crop Mark
(Align point 3)
Crop Mark
(Align point 1)
64
Crop mark Pinch roller
90 mm or more
(3.5 in. or more)
22.5 mm (0.89 in.)
Area where output
is possible
22.5 mm (0.89 in.)
80 mm or more
(3.2 in. or more)
Where to cut the media off
1.5 mm
(about 0.06 in.)
Crop Mark
(Align point 2)
Crop Mark
(Base point)