Roland TrueVIS VG-640 User Manual page 191

Message
[PINCHROLL ERROR
*** FROM RIGHT]
[WRONG CARTRIDGE]
[CANCELED FOR
PUMP PROTECTION]
[AVOIDING DRY-UP
TURN POWER OFF]
[SET HEAD HEIGHT
TO xxx]
Situation/error cause
The middle pinch rollers are
positioned at locations where
they cannot pinch the media.
There are too many middle
pinch rollers installed.
Has an ink pouch that cannot
be used been installed?
The printer made an emergen-
cy stop because the following
state has continued for 10 min-
utes or longer while cleaning
(normal, medium, powerful,
super, or automatic cleaning
while sub power was switched
off ) was in progress or during
the first ink filling procedure for
the machine.
The print heads were forced to
the home position to prevent
them from drying out.
Is the height of the print heads
lower than the height specified
in the software RIP?
An Error Message Appears
Action
Raise the loading lever and move the middle pinch
rollers to the correct location.
" P. 29 "Step 1 : Loading Roll Media (Setup of Media)"
" P. 72 "Loading Sheet Media (Setup of Media)"
Raise the loading lever, and then remove all middle
pinch rollers that are not positioned above grit roll-
ers. The number of middle pinch rollers used varies
according to the width of the loaded media.
" P. 29 "Step 1 : Loading Roll Media (Setup of Media)"
" P. 72 "Loading Sheet Media (Setup of Media)"
Remove the pouch tray to clear the error. Use an ink
pouch of the specified type.
Operation cannot be continued. Switch off the sub
power. After you switch off the power, contact your
authorized Roland DG Corp. dealer.
Operation cannot be continued. Switch the sub
power off, then back on.
This warning indicates that the height of the print
heads is too low for the media thickness specified
in the software RIP. The print heads move to a loca-
tion where you can operate the height-adjustment
lever. Adjust to the displayed height, and then
press [ENTER].
" P. 128 "Adjusting Print Head Height to Match Media
Thickness"
6
189