Setting The Origin Point; About Tools And Materials - Roland CAMM SCRIBE CS-20 User Manual

Setting the Origin Point

The origin point set with the software determines the position on the CAMM SCRIBE that is set.
Usually, the origin on the CAMM SCRIBE is set to a location at the front left of the material secured in place.
This section explains how to set the origin point at the front left of a piece of material.
Use the arrow keys to move the tool to the front
1
left area of the loaded material.
* The origin point that is set here remains in
memory even when the power is switched off.

About Tools and Materials

The combinations of appropriate tools and materials for the different modes are shown below. Please refer to this to make the
correct selections.
Please be aware that conditions may vary depending on factors such as the sharpness of the tool and the hardness of the material.
When performing cutting, it is not possible to cut thin, soft vinyls.
*Material thickness -- Up to 5 mm (3/16")
*Engraving depth ---- Varies according to the type of material.
To achieve deep engraving on a hard material, repeatedly carry out engraving at the same location,
extending the blade tip slightly with each pass.
Hold down the SET ORIGIN POINT key until
2
its LED lights up (about two seconds).
The origin point has now been set.
Model numbers in parentheses ( ) are for optional items.
11