Nortel COMMISSIONING 8600 Commissioning page 50

50 Initial steps using the CLI
Table 7
Job aid: PPP file options
Option
asyncmap <value>
chap_file <file>
chap_interval <value>
chap_restart <value>
debug
default_route
driver_debug
escape_chars <value>
ipcp_accept_local
ipcp_accept_remote
ipcp_max_configure <value>
Copyright © 2008 Nortel Networks
.
Nortel Ethernet Routing Switch 8600
Commissioning
NN46205-319 01.01 Standard
30 May 2008
Description
Configures the desired async map to
the value you specify.
Obtains Challenge-Handshake
Authentication Protocol (CHAP)
secrets from the specified file. You
require this option if either peer
requires CHAP authentication. If your
users must use the same IP address,
the PAP and CHAP secret files must
specify the same IP address for all
users and it must match the peer-ip
setting on the modem port.
Configures the interval, in seconds, for
the CHAP rechallenge to the value you
specify.
Configures the timeout, in seconds,
for CHAP negotiation to the value you
specify.
Activates the PPP daemon debug
mode.
Adds a default route to the system
routing table, after successful Internet
Protocol Control Protocol (IPCP)
negotiation. Use the peer as the
gateway. After the PPP connection
ends, the system removes this entry.
Activates PPP driver debug mode.
Configures the characters to escape
on transmission to the value you
specify.
Accepts what the remote peer uses as
the target local IP address, even if the
local IP address is specified.
Accepts what the remote peer uses as
the IP address, even if you specify the
remote IP address.
Configures the maximum number of
transmissions for IPCP configuration
requests to the value you specify.