Nortel COMMISSIONING 8600 Commissioning page 121

3
Variable definitions
Use the data in the following table to use the boot config host
command.
Variable
ftp-debug
password <value>
tftp-debug
tftp-hash
tftp-rexmit
<seconds>
Copyright © 2008 Nortel Networks
.
Reboot the switch.
Value
Enables or disables debug mode on FTP. If you
enable debug mode, debug messages appear on the
management console screen. The default is disabled.
Use the no operator to later remove this configuration.
To configure this option to the default value, use the
default operator with the command.
Configures the password to enable FTP transfers.
value is the password, up to 16 characters long.
After you configure this password, only FTP is used for
remote host logon
ATTENTION
This password must match the password for the
FTP server, or the FTP operation fails. Also, if you
configure the password to a valid value, then all
copying to and from the network uses FTP instead
of TFTP. If the user name or password is incorrect,
copying over the network fails.
Enables or disables debug mode on TFTP/TFTPD.
If you enable debug mode, debug messages display
on the management console screen. The default
is disabled. Use the no operator to remove this
configuration. To configure this option to the default
value, use the default operator with the command.
Enables or disables the TFTP hash bucket display.
The default is disabled. Use the no operator to remove
this configuration. To configure this option to the
default value, use the default operator with the
command.
Configures the TFTP retransmission timeout. The
default value is 2 seconds. seconds is the number of
seconds (1–120).
To configure this option to the default value, use the
default operator with the command.
Nortel Ethernet Routing Switch 8600
Commissioning
NN46205-319 01.01 Standard
30 May 2008
Configuring the remote host logon 121
--End--