Page 184 of 258
553-3001-207
Standard 2.00
Dialing Plan configuration
CLTP NATL
...
SPN
1015
FLEN 10
...
RLI
30
CLTP LOCL
...
SPN
1016
FLEN 10
...
RLI
30
CLTP LOCL
...
Procedure 12
Configuring the NRS database
After configuring main office routing to the NRS, the NRS database must be
provisioned to identify the desired endpoint for the calls. This procedure
configures the NRS database with the inserted digits specified by the zone-
based digit manipulation configuration.
Note: Instead of configuring the NRS database, you can configure a
route in the main office to directly route the call (see step 4 on
This procedure provides information specific to the configuration of the NRS
database for this application. Refer to IP Peer Networking: Installation and
Configuration (553-3001-213) for complete details on configuring the NRS.
1
Click the Configuration tab in NRS.
2
Click set Standby DB view to work in the standby (inactive) database.
3
Select Routing entries from the navigation menu on the left-hand side of
the Network Routing Service window.
The Routing Entries window opens, as shown in Figure 57 on
January 2006
7 digits for long-distance + 3 digits for ZDP
7 digits for long-distance + 3 digits for ZDP
page
181).
page
185.