Nortel Remote Gateway 50 Configuration Manual page 233

LD 117 – Configure branch office zone ESA route.
Command
CHG ZESA <Zone><ESA Route #><AC><ESA Prefix><ESA Locator>
Main Office Configuration for Survivable Remote Gateway 50
a. Configure the branch office zone's ESA dialing information in
LD 117.
Description
Defines the ESA parameters for the
• Zone = Zone number for the
• ESA Route # = Virtual Trunk route to SRG.
• AC = Access Code to add to dialed digits. If no AC is required, enter
AC0 in place of AC1 or AC2.
• ESA Prefix = Digit string added to start of ESDN. This is a unique prefix
in the NRS. Nortel recommends that users use "0" + ESN location code
branch
of the office node. An example for location code 725 would be:
0725.
• ESA Locator = Direct Inward Dial telephone number sent as part of ANI
for use by the PSAP to locate the source of the call.
b. Enable the
ENL ZBR <Zone> ESA
7 Configure the ESA Special Number at the main office.
a. Configure the ESA Special Number in the NRS. Using NRS,
configure the ESA Special Number defined for the
zone. Refer to IP Peer Networking: Installation and Configuration
(553-3001-213).
Nortel recommends that customers use "0" + the ESN Location code
+ ESDN. An example for location code 725 would be 0725911. The
zero is recommended to prevent a collision in the ESN data with the
HLOC entry.
Emergency Services configuration
branch
branch
branch
office zone ESA in LD 117.
Page 233 of 258
office zone, where:
office.
branch
Configuration Guide
office