Figure 12
Effect of the default CQos Coefficient
Main Office Configuration for Survivable Remote Gateway 50
loss (Cpl), jitter (Cj), delay (Cd), and the R factor (Cr) — can be configured
and are used to calculate the rate of bandwidth change. Increasing them from
their default values causes the Sliding Maximum to decrease faster in
response to the specific QoS alarm.
The QoS Coefficient (CQoS) can be varied from its default value. Increasing
this value causes the Sliding Maximum to change more rapidly in response to
QoS alarms. However, making this value too large will result in loss of
overall bandwidth, as shown in Figure 12 below and Figure 13 on
Bandwidth Management
Page 73 of 258
page
74.
Configuration Guide