Configuration Procedures; Default Configurations; Table 9 Passport 8683Pos Module Default Settings - Nortel Passport 8683POS Using Manual

54 Chapter 4 Managing the Passport 8683POS Module

Configuration procedures

You can configure the Passport 8683POS Module in two basic modes:
• Bridging: Bridging mode is enabled by default. Bridging is configured for
connections between two Passport 8683POS Modules and between Passport
8683POS Modules and other devices that support PPP bridging.
• Routing: You select routing mode for connections between your Passport
8683POS Module and other POS-capable routers for IP and IPX routing.
Use Device Manager and/or CLI to perform these configuration and related tasks
on the Passport 8683POS Module. For information on advanced configurations,
refer to Getting Started with Passport 8000 Series Management Software.
This section describes the following:
•

"Default configurations,"

• "Basic procedures" on page 55
• "Configuring bridging" on page 62
Default configurations
The Passport 8683POS Module has the following default configurations.
Table 9

Table 9 Passport 8683POS Module default settings

Parameter
Bridge Admin State (BCP)
IP Admin State (IPCP)
IPX Admin State (IPXCP)
Clock source
FCS size
Debug
Framing
Priority
209564-A
describes the default settings.
next
Default
Open
Close
Close
Line
32
Disabled
SONET
Low