Test Commands - Nortel Passport 8683POS Using Manual

monitor ports stats pos lineinterval <intervalid> [<ports>]
monitor ports stats pos linkstatus [<ports>]
monitor ports stats pos lqrstatus [<ports>]
monitor ports stats pos pathcurrent [<ports>]
monitor ports stats pos pathinterval <intervalid> [<ports>]
monitor ports stats pos pppiftbl [<ports>]
monitor ports stats pos sectioncurrent [<ports>]
monitor ports stats pos sectioninterval <intervalid>
[<ports>]
monitor ports stats pos sonetmediumtbl [<ports>]

Test commands

This section describes the test commands available with the Passport 8683POS
Module. The test commands allow you test the module while the switch is
operating. The tests do not interfere with the module's normal switching
functions, but they do occupy the CPU. The test commands allow you to test:
• Hardware
• LEDS
• Internal and external loopback
The syntax for the test commands is:
test hardware <ports>
test led <ports> <tx|rx> <off|yellow|green>
test loopback <ports> [<int|ext>]
Chapter 6 Command line interface
Using the Passport 8683POS Module
127