Using The Test Commands; Test Hardware; Test Led; Figure 52 Test Hardware Command Output - Nortel Passport 8683POS Using Manual

128 Chapter 6 Command line interface

Using the test commands

Refer to the Reference for the Passport 8000 Series Command Line Interface
Switching Operations, Release 3.1 and Reference for the Passport 8000 Series
Command Line Interface Routing Operations, Release 3.1 for a complete list of
CLI test commands.

test hardware

Use the test hardware command to run diagnostics on the Passport 8683POS
Module. The command uses the following syntax:
test hardware <ports>
The output from the test hardware command is shown in

Figure 52 test hardware command output

Passport-8610:test hardware 10/5
Port: 10/5
IfIndex: 645
Result: success

test led

Use the
correctly on the Passport 8683POS Module. The command uses the following
syntax:
test led <ports> <tx|rx> <off|yellow|green>
209564-A
Note: You must specify a slot and port number with the test commands.
command to see if the lights on the port LEDs are functioning
test led
Figure 52.