Table of Contents
Advertisement
124
Chapter 6 Command line interface
Table 51 Information fields for output of the show ports stats pos sonetmediumtbl
command
Field
PORT NUM
MEDIUM TYPE
TIME ELAPSED
VALID INTERVALS
LINE CODING
LINE TYPE
CIRCUIT ID
show tech command
The
show tech
Figure 51
209564-A
command has the following syntax:
show tech
shows sample output for the show tech command.
Description
Port number.
Identifies whether a sonet or sdh signal is used across the
interface.
Number of seconds, including partial seconds, that have
elapsed since the beginning of the current measurement
period. If the current interval exceeds the maximum value,
the agent will return the maximum value.
Number of previous 15-minute intervals for which data was
collected.
Line coding for this interface. The B3ZS and CMI are used
for electrical SONET/SDH signals (STS-1 and STS-3). The
Non-Return to Zero (NZR) and the Return to Zero are used
for optical SONET/SDH signals.
Line type for this interface. The line types are Single Mode
fiber or Multi-Mode fiber interfaces.
Transmission vendor's circuit identifier, to facilitate
troubleshooting.
Advertisement
Table of Contents
