Table of Contents
Advertisement
Configuring IPX routing using the CLI
To configure the Passport 8683POS Modules for IPX routing using the CLI:
1
Configure a protocol-based VLAN. and assign the port to the VLAN as a
static member and ensure that no other ports are allowed to join.
Refer to Reference for Passport 8000 Management Software Routing
Operations for information on how to configure VLANs using CLI.
2
To disable the selected port on both Passport 8683POS Modules, enter:
config pos <ports> state disable
3
To disable bridging, enter:
config pos <ports> bridge-admin-status close.
4
To configure IPX routing, enter:
config pos <ports> ppp ipx-admin-status open.
5
To enable the selected port on both Passport 8683POS Modules, enter:
config pos <ports> state enable
See
CLI commands.
Trap feature
The Passport 8600 chassis with a functioning Passport 8683POS Module
automatically receives SONET-specific traps.
To configure the device for SONET-specific traps:
1
In Device Manager, select the chassis.
The frame of the chassis is highlighted.
2
Choose Edit > Chassis.
The Chassis dialog box opens with the System tab displayed
Chapter 4 Managing the Passport 8683POS Module
Chapter 6, "Command line interface," on page 91
for descriptions of the
Using the Passport 8683POS Module
71
(Figure
20).
Advertisement
Table of Contents
