Table of Contents
Advertisement
Important: 120 Volt AC power is needed for the fan switch and blower.
The receptacle box will be installed on the left hand side of the unit
and must be wired by a qualified electrician prior to fan
assembly being installed. The neutral(wider) slot of the polarized
receptacle should be at the top.
Ground terminal must not be removed.
Unit must be grounded at all times.
1) Turn the power off, unplug accent lights if installed.
2) Remove the mesh barrier and the standard flush door.
3) Remove fan assembly from box, locate green ground wire and pull
out of fan assembly - taking care not to damage or cut wire casing.
4) Position the fan base with the motor end towards the rear of the
firebox and then slide the fan in towards the rear of the unit. Turn
the fan housing slightly to the left and make the fan assembly paral-
lel to the rear wall.
5) Lift the fan housing upwards and slip it over the two mounting
studs. (use of dish soap will help the rubber grommets slide down
over the pins)
NOTE: If optional accent lights are installed,take care when sliding the
fan into position. Fan must be maneuvered around the right
side of the light.
919-439
OPTIONAL FAN INSTALLATION
OPTIONAL FAN INSTALLATION
1
9) Slide the thermodisc/cover assembly onto the bracket clip on the
left underside of the firebox. Ensure that no wires will touch hot
surfaces.
7) Connect and secure fan ground cable to ground lug.
8) Plug fan power cord into the Fan Control Module (FCM) then plug
in the FCM. The switch is on when pushed to the left. (Shown in OFF
position above)
Regency Bellavista™ B36XTE-10 Gas Fireplace
B41XTE
installation
|
09.30.14
47
|
47
Advertisement
Table of Contents
