Optional Fan Installation - Regency C34 Classic Owners & Installation Manual

installation
|
18

OPTIONAL FAN INSTALLATION

OPTIONAL FAN INSTALLATION
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged (grounding) plug for your
protection against shock hazard and should be plugged directly into a
properly grounded receptacle.
Pedestal unit: To install the fan in an installed stove-access from front through
the pedestal by following the directions below. If the stove is not
installed - access through the back - open back as shown below.
Leg unit: Loosen 7 screws on bottom access panel–slide panel toward the
front to remove.
IMPORTANT Disconnect power supply before servicing
1. Open pedestal door and remove door cover plate by removing 4 screws.
See Diagram 3.
2. Remove valve cover plate by removing 2 screws.
3. Remove wire from receiver.
4. Screw the four screws provided into the nutserts as shown in Diagram 5.
Do not tighten screws.
5. Place the fan assembly partially in door cover plate hole. See Diagram 4.
6. Attach the 2 ground wires (green) to the ground lug as per Diagram 4.
920-109
18 |
Regency ® CLASSIC™ C34-11 Direct Vent Freestanding Gas Stove
Diagram 1
Remove 7 screws on top
Loosen 4 screws on bottom–
slide access panel to the right
to remove
Diagram 2
Loosen 6 screws–slide access
panel to the front of unit to
remove
Diagram 3
Note: Ground lug is located on the bottom of the fan assembly. See
Diagram 4.
7. Lift the fan assembly in through the pedestal and up through the cut out
as shown in Diagrams 5 and 6.
8. Place the insulation gasket on the back of the fan. Line up the keyhole
slots with the matching screws and pull back slightly to lock into place.
While holding fan assembly in place, tighten screws.
9. Slide thermodisc under the thermodisc bracket.
C34E-11
Diagram 4
Diagram 5
Diagram 6
Diagram 7
05.23.19