Table of Contents
Advertisement
installation
|
42
• Black Enamel panels must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
• Black Enamel panels will discolor a little during normal operation. This is normal and should not be considered a defect.
*
All hand and fi nger marks MUST be cleaned off with a soft cloth.
gerprints before applying heat to the unit.
Failure to do this will result in burn stains on panels which you will be unable to remove. Not protected by product warranty.
RIGHT
1) Remove the heat defl ector by removing the 2 screws securing the
heat defl ector to the top of the fi rebox (see Diagram 2).
Heat defl ector
2) Install the back panel fi rst - use care when clearing the burner assembly
and rear log tray, so panel is not scratched.
42 |
Regency Bellavista™ B36XTE-10 Gas Fireplace
918-807a
OPTIONAL ENAMEL PANEL INSTALLATION
BLACK ENAMEL PANEL INSTALLATION
TOP
BACK
LEFT
Diagram 1
Diagram 2
Diagram 3
Black Enamel Panels
Use an ammonia based cleaner (ie. glass cleaner) to remove any fi n-
3) Install the top panel next - slide the panel in over top of the back panel
- orient the panel so the fold in the metal faces in (see inset A).
Diagram 4
4) Remove 1 screw (see inset A), position right side panel in fi rebox -
position panel clip in place and secure with 1 screw (see inset B).
Tighten the screw.
Diagram 5
5) Repeat step 4 for left side panel.
6) Reverse step 1.
1
B36X / XT
Fold
Final Installation
A
A
B
Diagram 6
05/15/12
Advertisement
Table of Contents
