Table of Contents
Advertisement
The unit comes equipped as a rear vent unit. These instructions are to be used, only if the unit is going to be top vented.
Top Collar Assembly Kit
1
Intake Collar Assembly with Gasket
1
Intake Cover Plate with Gasket
1
Top/Rear Exhaust Assembly with Gasket
1
Heat Deflector
1
Baffle Plate
29
1/4" x 1/2" Screws (4 spares)
1
Restrictor
1
Intake Collar Gasket (spare)
1
Exhaust Assembly Gasket (spare)
1
Insulation Plate Cover
1
Insulation Filling
1) Remove the door assembly by releasing the adjustable latches and lifting up off the door frame assembly.
2) From inside the firebox, remove the top heat deflector by removing
2 screws.
Heat Deflector
3) From inside the firebox, remove the baffle plate by removing 4 screws
- remove top front screw first. See Diagram 3.
Baffle Plate
CONVERSION TO TOP VENT
Note: This conversion must be done prior to the unit being placed in position.
Adjustable Tension
Latch location
Diagram 2
Diagram 3
Exhaust Assembly
w/ gasket
Intake Collar Assembly
w/gasket
Insulation cover
plate
Note: Components shown are installed on unit.
4) From the inside of the firebox, remove the exhaust assembly by
removing the 8 screws. See Diagram 4.
Diagram 4
Regency Bellavista™ B36XTE-10 Gas Fireplace
installation
Intake Cover Plate
w/gasket
Insulation filling
Diagram 1
|
17
|
17
Advertisement
Table of Contents
