Table of Contents
Advertisement
installation
|
50
11) After the wiring has been connected, secure green ground wire to
ground lug as shown below.
Ground lug is located on the lower left corner inside the
bottom of the unit.
Ground
Lug
12) Using the adhesive wire holder, neatly secure the loose wiring to
the base of the unit.
Ensure wiring does not come into contact with the fan blades
or any sharp metal edges.
13) Reinstall the rear log tray - secure with 2 screws.
50 |
Regency Bellavista™ B36XTE-10 Gas Fireplace
918-821a
14) Install the halogen bulb supplied with the kit.
Important: Use caution - do not touch the bulb during
installation. Use the plastic packaging as a protective
covering while installing the bulb.
15) Install a gasket over top of the bulb.
16) Install the light diffuser by securing it to the rear log tray with 2
screws - see below.
Installed diffuser shown below with 2 options:
a) With amber glass plate - for use with units without panels or
with brick panels. Left and right side tabs to be bent down 90
degrees as shown below (Image A).
b) Amber glass plate covered - for use with units using stainless
steel / black enamel panels as show below in Image B.
Wire Clip
2
A
B
B
Gasket
08/13/14
Advertisement
Table of Contents
