Optional Accent Light Installation - Regency Bellavista B36XTE Owners & Installation Manual

Hide thumbs Also See for Bellavista B36XTE:
Table of Contents

Advertisement

B36XT/B36XTE Accent Light Kit # 576-959
1
Light Assembly
1
910-997
1
940-363
1
910-199
1
918-821
Important: 120 Volt AC power is required to operate the light.
The receptacle box will be installed on the left hand side of the unit
and will need to be wired by a qualifi ed electrician prior to the light
installation. The neutral (wider) slot of the polarized receptacle
should be at the top. A wall mounted switch should also be installed
to turn the accent light on and off.
Note: Receptacle Box is switch operated.
Refer to wiring diagram in the manual.
1) Shut off electrical supply.
2) Remove the mesh guard and glass door.
3) Remove the logs - if installed.
4) Remove the rear log tray by removing 2 screws (locations shown
below) then lifting out.
5) Remove the 2 screws securing the cover plate to the fi rebox base.
Discard cover plate - keep the 2 screws.
Cover plate
6) From inside the fi rebox - feed the wires
from the bottom of the light assembly
- through the opening exposed after the
removal of the cover plate.
918-821a

OPTIONAL ACCENT LIGHT INSTALLATION

OPTIONAL LIGHT INSTALLATION
-includes cable tie/ gasket.
Halogen Bulb
Amber glass
Adhesive wire clip
Instruction Sheet
Rear Log Tray
Light assembly
wiring
7) When light assembly has been fully seated -
secure in place with 2 screws that were removed from the
cover plate
8) From underneath the fi rebox - slide back the protective sheath
on the plug wiring to reveal connectors.
Connectors
9) Plug the red light assembly wiring into the blue plug wiring - as
shown below.
NOTE: The ground wire will need to be pulled back out of the protective
casing to be able to reach the ground lug. Gently pull the end
of the green wire backwards exposing enough wire to reach
ground lug.
10) Slide protective sheath back over connectors until it meets the
underside of the fi rebox base - to protect wires.
Secure end of sheath with a cable tie.
Cable Tie
Regency Bellavista™ B36XTE-10 Gas Fireplace
1
installation
Protective Sheath
08/13/14
|
49
|
49

Advertisement

Table of Contents
loading

Table of Contents