Virtual Link Add/Edit Screen - ZyXEL Communications USG40 User Manual

Hide thumbs Also See for USG40:

Table of Contents

Table 108 Configuration > Network > Routing > OSPF > Add (continued)

Peer Router ID

Authentication

9.7.3 Virtual Link Add/Edit Screen

The Virtual Link Add/Edit screen allows you to create a new virtual link or edit an existing one.

When the OSPF add or edit screen (see

Virtual Link table displays. Click either the Add icon or an entry and the Edit icon to display a

screen like the following.

Figure 171 Configuration > Network > Routing > OSPF > Add > Add

Chapter 9 Routing

Double-click an entry or select it and click Edit to open a screen where you can modify

the entry's settings.

To remove an entry, select it and click Remove. The ZyWALL/USG confirms you want

to remove it before doing so.

This field is a sequential value, and it is not associated with a specific area.

This is the 32-bit ID (in IP address format) of the other ABR in the virtual link.

This is the authentication method the virtual link uses. This authentication protects the

integrity, but not the confidentiality, of routing updates.

None uses no authentication.

Text uses a plain text password that is sent over the network (not very secure). Hover

your cursor over this label to display the password.

MD5 uses an MD5 password and authentication ID (most secure). Hover your cursor

over this label to display the authentication ID and key.

Same as Area has the virtual link also use the Authentication settings above.

Click OK to save your changes back to the ZyWALL/USG.

Click Cancel to exit this screen without saving.

Section 9.7.2 on page

ZyWALL/USG Series User's Guide

252) has the Type set to Normal, a

Show Quick Links

Table of Contents