ZyXEL Communications USG40 User Manual page 209

Table 85 Configuration > Network > Interface > VLAN > Create Virtual Interface (continued)
LABEL DESCRIPTION
Add Click this to create a new entry.
Edit Select an entry and click this to be able to modify it.
Remove Select an entry and click this to delete it.
# This field is a sequential value, and it is not associated with a specific entry.
IP Address Enter the IP address to assign to a device with this entry's MAC address.
MAC Address Enter the MAC address to which to assign this entry's IP address.
Description Enter a description to help identify this static DHCP entry. You can use alphanumeric
and ()+/:=?!*#@$_%- characters, and it can be up to 60 characters long.
RIP Setting See
Enable RIP Select this to enable RIP on this interface.
Direction This field is effective when RIP is enabled. Select the RIP direction from the drop-down
list box.
BiDir - This interface sends and receives routing information.
In-Only - This interface receives routing information.
Out-Only - This interface sends routing information.
Send Version This field is effective when RIP is enabled. Select the RIP version(s) used for sending
RIP packets. Choices are 1, 2, and 1 and 2.
Receive Version This field is effective when RIP is enabled. Select the RIP version(s) used for receiving
RIP packets. Choices are 1, 2, and 1 and 2.
V2-Broadcast This field is effective when RIP is enabled. Select this to send RIP-2 packets using
subnet broadcasting; otherwise, the ZyWALL/USG uses multicasting.
OSPF Setting See
Area Select the area in which this interface belongs. Select None to disable OSPF in this
interface.
Priority Enter the priority (between 0 and 255) of this interface when the area is looking for a
Designated Router (DR) or Backup Designated Router (BDR). The highest-priority
interface identifies the DR, and the second-highest-priority interface identifies the BDR.
Set the priority to zero if the interface can not be the DR or BDR.
Link Cost Enter the cost (between 1 and 65,535) to route packets through this interface.
Passive Select this to stop forwarding OSPF routing information from the selected interface. As
Interface
a result, this interface only receives routing information.
Authentication Select an authentication method, or disable authentication. To exchange OSPF routing
information with peer border routers, you must use the same authentication method
that they use. Choices are:
Same-as-Area - use the default authentication method in the area
None - disable authentication
Text - authenticate OSPF routing information using a plain-text password
MD5 - authenticate OSPF routing information using MD5 encryption
Text This field is available if the Authentication is Text. Type the password for text
Authentication
authentication. The key can consist of alphanumeric characters and the underscore,
Key
and it can be up to 16 characters long.
MD5 This field is available if the Authentication is MD5. Type the ID for MD5
Authentication
authentication. The ID can be between 1 and 255.
ID
Chapter 8 Interfaces
Section 9.6 on page 246 for more information about RIP.
Section 9.7 on page 248 for more information about OSPF.
ZyWALL/USG Series User's Guide
209