ZyXEL Communications USG40 User Manual page 184

Figure 136 Configuration > Network > Interface > Cellular
The following table describes the labels in this screen.
Table 80 Configuration > Network > Interface > Cellular
LABEL DESCRIPTION
Add Click this to create a new cellular interface.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify
the entry's settings.
Remove To remove an entry, select it and click Remove. The ZyWALL/USG confirms you want to
remove it before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
Connect To connect an interface, select it and click Connect. You might use this in testing the
interface or to manually establish the connection.
Disconnect To disconnect an interface, select it and click Disconnect. You might use this in testing
the interface.
Object Select an entry and click Object Reference to open a screen that shows which settings
References use the entry. See
# This field is a sequential value, and it is not associated with any interface.
Status The activate (light bulb) icon is lit when the entry is active and dimmed when the entry is
inactive.
The connect icon is lit when the interface is connected and dimmed when it is
disconnected.
Name This field displays the name of the interface.
Extension Slot This field displays where the entry's cellular card is located.
Connected This field displays the name of the cellular card.
Device
ISP Settings This field displays the profile of ISP settings that this cellular interface is set to use.
Mobile You should have registered your ZyWALL/USG at myzyxel.com. Myzyxel.com hosts a list
Broadband of supported mobile broadband dongle devices. You should have an Internet connection to
Dongle Support access this website.
Latest This displays the latest supported mobile broadband dongle list version number.
Version
Chapter 8 Interfaces
Section 8.3.2 on page 173
ZyWALL/USG Series User's Guide
184
for an example.