Ricoh SP 3400N Operating Instructions Manual page 43

❖ Cardstock
Item
Paper thickness
Supported paper tray
Duplex supported size
Notes
❖ Label paper
Item
Supported paper tray
Duplex supported size
Notes
❖ OHP transparencies
Item
Supported paper tray
Duplex supported size
Notes
Description
2
105 to 160 g/m (28.0 to 42.6 lb.)
Tray 1 and bypass tray
None
• The number of sheets that can be printed in one minute is
approximately half that of plain paper.
• When using 135 g/m
may be output with strong curls.
• When using 135 g/m
prints from the output tray frequently.
• Paper thicker than 160 g/m
Description
Tray 1 and bypass tray
None
• The number of sheets that can be printed in one minute is
approximately half that of plain paper.
• Avoid using adhesive label paper on which glue is exposed.
Glue may stick to the inner parts of the printer, which can
cause paper feed problems, deterioration in print quality,
or premature wear of the print cartridge's photo conductor
unit.
Description
Bypass tray
None
• When loading OHP transparencies, take care not to load
them upside down. Doing so may cause a malfunction.
• It is recommended to place one sheet at a time.
• Make sure to fan OHP transparencies every time before
printing. Leaving OHP transparencies loaded in the by-
pass tray may cause them to stick together and result in a
misfeed.
• If multiple OHP transparencies are fed at the same time,
load them one by one.
• When printing on OHP transparencies, remove the trans-
parencies one by one as they are output.
Paper Recommendations
2
(35.9 lb.) or heavier paper, prints
2
(35.9 lb.) or heavier paper, take
2
cannot be printed onto.
4
37