Ricoh SP 3400N Operating Instructions Manual page 233

[Maintenance] Tab
Make settings for adjusting printing position.
Registration: Tray 1
Adjust the position of Tray1 if it is installed.
v [Print Test Sheet]
Click this button to check the printing position using a test print.
• Horizontal
After printing the test sheet, you can adjust the horizontal print position in
the range of from -15 to +15 in increments of 0.1 mm.
• Vertical
After printing the test sheet, you can adjust the vertical print position in the
range of from -15 to +15 in increments of 0.1 mm.
Registration: Tray 2
Adjust the position of Tray2 if it is installed.
v [Print Test Sheet]
Click this button to check the printing position using a test print.
• Horizontal
After printing the test sheet, you can adjust the horizontal print position in
the range of from -15 to +15 in increments of 0.1 mm.
• Vertical
After printing the test sheet, you can adjust the vertical print position in the
range of from -15 to +15 in increments of 0.1 mm.
Registration: Bypass Tray
Adjust the position of the print image on sheets fed from the bypass tray.
v [Print Test Sheet]
Click this button to check the printing position using a test print.
• Horizontal
After printing the test sheet, you can adjust the horizontal print position in
the range of from -15 to +15 in increments of 0.1 mm.
• Vertical
After printing the test sheet, you can adjust the vertical print position in the
range of from -15 to +15 in increments of 0.1 mm.
Printer Configuration
5