Ricoh SP 3400N Operating Instructions Manual page 128

Preparing for Printing
I
In the [Select Program Folder] dialog box, click [Next >].
J
When the [InstallShield Wizard Complete] dialog box appears, click [Finish].
To continue the installation, leave the [Printer Driver and Utilities] dialog box
1
open.
Note
❒ Smart Organizing Monitor will appear in the language selected in step 5,
not the language selected in step 3.
Specifying the printer's IP address
Use the following procedure to specify the printer's IP address using Smart
Organizing Monitor.
Important
❒ If the printer is obtaining its IP address automatically from a DHCP server,
you do not need to perform this procedure. Proceed to p.11 "Installing the
printer driver" and install the printer driver.
A
Connect the printer and computer using an Ethernet cable.
B
On the [Start] menu, point to [All Programs], and then point to [Smart Organiz-
ing Monitor for 3400 Series] > [Smart Organizing Monitor for 3400 Series Status].
The [Smart Organizing Monitor] dialog box appears.
In a Windows 2000 environment, point to [Programs] on the [Start] menu, and
then point to [Smart Organizing Monitor for 3400 Series] > [Smart Organizing Monitor
for 3400 Series Status].
C
Click [IP Address].
The [IP Address Setting] dialog box appears.
D
In the [MAC Address] box, enter the printer's MAC address that was printed
on the test page. Then, in the [IP Address] box, enter the IP address you want
to set for the printer.
Enter the subnet mask and gateway address if necessary.
E
Click [OK].
A confirmation message appears.
F
Click [OK].
G
Click [Close] to close the Smart Organizing Monitor dialog box.
10