Ricoh SP 3400N Operating Instructions Manual page 248

RinmeiP1ENSafety_Preface1 Page 6 Friday, October 16, 2009 11:20 AM
Handling the Machine
R CAUTION:
• Before moving the machine, unplug the power cord from the wall outlet. If
the cord is unplugged abruptly, it could become damaged. Damaged plugs
or cords can cause an electrical or fire hazard.
• Unplug the power cord from the wall outlet before you move the machine.
While moving the machine, you should take care that the power cord will
not be damaged under the machine.
• The machine weighs approximately 12 kg (26.4 lb.). When moving the ma-
chine, use the inset grips on both sides, and lift slowly. The machine will
break or cause injury if dropped.
• When moving the machine after use, do not take out the print cartridge to
prevent toner spill inside the machine.
• Do not connect the Ethernet port of the machine to a network that may sup-
ply excess voltage, such as a telephone line. Doing so may result in fire or
electric shock.
Handling the Machine's Interior
R WARNING:
• Do not attempt any maintenance or troubleshooting other than that
mentioned in this manual. This machine contains a laser beam gener-
ator and direct exposure to laser beams can cause permanent eye
damage.
R CAUTION:
• The inside of this machine becomes very hot. Do not touch parts labelled
"v" (indicating a hot surface).
• The fusing section of this machine might be very hot. Caution should be tak-
en when removing misfed paper.
• Lifting the paper feed unit carelessly or dropping it may cause injury.
• Do not pull out the paper tray forcefully. If you do, the tray might fall and
cause an injury.
6