Programming A F-Code Polling - Muratec F-98 Operating Instructions Manual

7
Use the numeric keypad to enter the
you want to send the document. Here, we've entered 123456:
Enter Sub-Address
123456_
8
Press . The shows:
ENTER LCD
Enter Password
_
Note: If the password for the box is not entered, press
to step 10.
9
Use the numeric keypad to enter the appropriate
Here, we've entered 654321:
Enter Password
654321_
When finished, press .
ENTER
10
If you want the transmission to begin immediately every time you press the
key, press and skip to step 13.
ENTER
If you want to delay the transmission (to take advantage of lower phone
rates, for example), press
COM
11
There's a choice to make. Instruct your fax to carry out this delayed command
in one of the following ways:
Option 1: Perform the command once at a certain time on a certain day of
the month. (For example, "Do this at 5:05
To select this option, use the numeric keypad to enter the date
and time when the fax should perform the command:
Delayed
Enter Time: 30/17:05
Option 2: Perform the command at a certain time each day you press the
key. (For example, "Do this at 5:05
To select this option, use the numeric keypad to enter 0, 0 (i. e.,
00), and then the time when the fax could perform the command:
Delayed
Enter Time: 00/17:05
12
Press , .
ENTER ENTER
- sub-address for the box to which
ITU T
and then skip
ENTER
- password for the box.
ITU T
- , .
OPTIONS ENTER
on the 30th.")
PM
today.")
PM
13
The now displays the next programmable one-touch key.
LCD
If you do not want to enter or change any other key's programming, press
to return your machine to its usual standby mode.
If you do want to enter or change this key's programming, go back to step 3.
If you want to enter or change another key's programming, go back to step 2.

Programming a F-Code polling

Note: To erase a programmable one-touch key, refer to page 2.41.
Note: For this operation to work, three things must be true:
• The document which you're polling must exist on the remote fax's F-Code
( - -standard sub-addressing/password) box.
ITU T
• You must know the remote fax's
for each box you wish to poll.
To program an F-Code polling into a programmable one-touch key:
1
Press , , 1, . The
PROGRAM C ENTER
Select Program No.
P1:No Number Stored
... or indicates a command is already programmed into this key.
If 1 is the key you want to program, skip to step 3. (However, our examples
P
from here will say " 4" rather than "
P
2
Select the key in which you want to program a command or change a previ-
ously stored command and then press it. Here, we've selected
Select Program No.
P4:No Number Stored
3
If you change your mind and want to select a different programmable one-
touch key, go back to step 2 before going on to step 4.
4
Press . The now shows either
ENTER LCD
P4:Fax Number
_
Beyond the basics
- sub-address and password (if any)
ITU T
either shows:
LCD
1.")
P
4.
P
P4:Fax Number
or
9-5552208_
STOP
2.39