Muratec F-98 Operating Instructions Manual page 72

Beyond the basics
Printing from your computer to your fax
With the -232 interface installed, you can now use your fax machine to print let-
RS C
ters, reports, graphics and other business correspondence directly from your
computer.
Here's how to use the printing feature:
1
Make sure your fax is connected to your computer (see page 2.43).
2
Computer: Use your application — for example, a word-processing program —
to send the document to your fax software, just as if you were actually going
to fax the document.
3
Fax machine: Make sure that you have stored your subscriber
1.11) on your machine.
4
Computer: When the fax software asks you to enter a fax number for sending
the document, enter your subscriber
5
Computer: Instruct your fax software to transmit. The fax machine will begin
to print.
Sending/receiving faxes with your computer
You can also receive documents from another fax onto your computer, as well as
transmit documents from your computer to other faxes. As with scanning, the exact
procedure for sending/receiving will depend on how your computer's particular fax
software works.
Note: Please consult your software's operating instructions for more details.
Still, here are the basics:
1
Make sure your fax is connected to your computer (see page 2.43).
2
Computer: If your fax software allows it, turn off Error Correction Mode
( ).
ECM
3
Computer: Instruct your fax software to send or receive. The fax machine will
begin either transmitting or receiving.
2.44
(see page
ID
.
ID
" " commands
AT
Note: This is a list of standard "
AT
more information, please consult the instructions for your fax software.
Command Parameter Description
A none Call answer
D 0-9, *, # Dial number
P Pulse dial
T Tone dial
, Pause
E 0 Not echo command character
1 Echo command character
H 0 On Hook (Disconnect line)
1 Off Hook (Connect line)
M 0 Monitor speaker is always off
1 Monitor speaker is on until carrier is
detected
2 Monitor speaker is always on
P none Set pulse dial mode
T none Set tone dial mode
V 0 Short formed response code
1 Long formed response code
Z none Reset modem
&F none Initialize to factory setting
\Q 1 / flow control
XON XOFF
2 / flow control
RS CS
+ ? none Indicate current service class
FCLASS
+ =? none Indicate service class capability
FCLASS
+ =n none Set service class
FCLASS
+ =n none Receive
FRH HDLC
+ =n none / flow control (n=1)
FLO XON XOFF
none / flow control (n=2)
RS CS
+ =n none Facsimile receive message
FRM
(14400/12000/9600/7200/4800/2400bps)
+ =n none Detect silence for n 10ms
FRS
+ =n none Transmit
FTH HDLC
+ =n none Facsimile transmit message
FTM
(14400/12000/9600/7200/4800/2400bps)
+ =n none Wait for n 10ms
FTS
" commands, which control your modem. For
Default value
frame (n=3:300bps)
+
frame (n=3:300bps)
E0
M1
V1
\Q2
=2
FLO