Errors - Muratec F-98 Operating Instructions Manual

Just in case ...
What you see on the
LCD
Reset Document
Scanner In Use
Sub-Address In Use
Too Many Characters
Too Many Locations
3.8
What it means/What to do
Your document wasn't inserted correctly, or the
fax to which you're sending can't handle the doc-
ument's page length. Reset the page and try
again.
The command you're trying to enter requires the
use of the scanner, which is already in use. Wait
for the fax to complete the scan, then try again.
You tried to enter a sub-address identical to one
already being used in another F-Code box. Enter
a different sub-address.
You attempted to enter too many numbers or
other characters in the current operation. Press
to delete the extra characters, then try
CANCEL
again. You may want to review the operation's
instructions.
You tried to enter too many numbers for a
broadcast initiation. You can enter up to 10
groups. Press to delete the extra numbers
CANCEL
and try again.

Errors

When sending faxes, your machine occasionally will run into communications errors.
These can be caused by anything from lightning to telephone line interference.
(These same factors cause the static, or line noise, you sometimes hear on phone
calls.) They also can be caused by problems with the fax machine at the other end of
the line.
Often, simply trying your call again is all that's necessary. However, if the problem
persists regularly, call your local telephone company for help. If that doesn't help and
the problem persists regularly, call your authorized Muratec dealer.
Error reports
When an error occurs, your fax machine prints an error report. Each fax error
report lists an error message which includes:
• A possible solution to the problem
• The sending location (if the remote fax stores a Location
• The result — which is a special error code.
• A sample of the document's first page.
Kinds of error codes
The error code listed in the "Result" column of the error report indicates the specific
problem encountered:
• " " codes — Occur while dialing
D
• " " codes — Occur during reception
R
• " " codes — Occur during transmission
T
of its own)
ID