Remote Management Setup - Enterasys VH-2402-L3 Management Manual

•
The Management VID:[ALL] field allows the entry of a
VLAN ID (VID) from which a management station (a
computer) will be allowed to manage the switch using
TCP/IP (in-band, or over the network). Management
stations that are on VLANs other than the one entered in
the Management VID:[ALL] field will not be able to
manage the switch in-band unless their IP addresses are
entered in the Management Station IP Addresses:
field. Any VID that has been configured on the switch
can be entered in this field.

Remote Management Setup

Some settings must be entered to allow the switch to be
managed from an SNMP-based Network Management
System such as SNMP v1 or to be able to access the Switch
using the TELNET protocol or the WEB-based Manager.
Please see the next chapter for Web-based network
management information.
To setup the switch for remote management:
Highlight Remote Management Setup from the main menu.
The following screen appears:
20 VH-2402-L3 Management Guide
a number (represented in decimal) between 0
and 255. The value should be 255.0.0.0 for a
Class A network, 255.255.0.0 for a Class B
network, and 255.255.255.0 for a Class C
network, but custom subnet masks are allowed.
Default Gateway - IP address that determines
where packets with a destination address outside
the current subnet should be sent. This is usually
the address of a router or a host acting as an IP
gateway. If your network is not part of an intranet,
or you do not want the Switch to be accessible
outside your local network, you can leave this
field unchanged.
9033691-01