Enterasys VH-2402-L3 Management Manual page 58

Figure 1-37. Setup IEEE 802.1Q Multicast Forwarding
When the switch is in Layer 2 operating mode, IEEE 802.1Q
multicast forwarding allows the static entry of multicast MAC
addresses, which will be sources of multicast packets, and
switch port numbers, to which these multicast packets will be
forwarded. The ports that can be chosen as the destination
for multicast packets from the above MAC multicast address,
are limited to the ports belonging to the VLAN that
corresponds to the VID entered in the VID:[2 ] field.
Each port of a given VLAN can be configured as an egress
member, a forbidden non-member, or as a non-member of
the multicast group that will receive multicast packets from
the multicast MAC address, by toggling the entry below each
port of the VLAN to the appropriate code.
Parameter
Action:<Add/Modify>
50 VH-2402-L3 Management Guide
Description
The field can be toggled between
Add/Modify and Delete using the space
bar. To add a new entry to the multicast
forwarding table, select Add/Modify and
enter the VID of the VLAN that will be
receiving the multicast packets. Enter
the MAC address of the multicast source,
and then enter the member ports.
9033691-01