Enterasys VH-2402-L3 Management Manual page 48

Ingress
Filter:<Disable>
GVRP:<Disable>
Each port can be configured to use an Ingress Filter, to
enable or disable GVRP. The ports to be configured in a
given session can be identified by either entering a range of
port numbers or by entering the PVID#.
To configure a port's 802.1Q VLAN settings:
Highlight the Configure Port from [ ] to [ ] field and enter
the range of port numbers you want to configure. As an
alternative you can use the arrow keys to highlight the
PVID#[ ] field and enter the PVID for the VLAN's member
ports you want to configure.
Use the arrow keys to highlight the remaining fields and the
space bar to toggle between On and Off.
To edit an existing 802.1Q VLAN:
40 VH-2402-L3 Management Guide
specific VLAN and is used to make
forwarding decisions for untagged
packets received by the port. For
example, if port #2 is assigned a PVID of
3, then all untagged packets received on
port #2 will be assigned to VLAN 3. This
number is generally the same as the VID#
number assigned to the port in the Edit
802.1Q VLANs menu above.
This field can be toggled using the space
bar between Enable and Disable.
Enable enables the port to compare the
VID tag of an incoming packet with the
PVID number assigned to the port. If the
two are different, the port filters (drops)
the packet. Disable disables Ingress
filtering.
Group VLAN Registration Protocol
(GVRP) – this enables the port to
dynamically become a member of a
VLAN.
9033691-01