Table of Contents
Advertisement
The field Select switch operation mode:<
toggled using the space bar to one of the two switch
operation modes: Layer 2 Only, Support IEEE 802.1Q
VLANs and IP Routing, Support IEEE 802.1Q VLANs.
To make a change in the operation mode of the switch
effective, highlight APPLY and press enter.
Figure 1-21. Change Mode Confirmation Screen
Type y and press Enter. The switch will then save the
changes made during the current session and reboot. The
switch must be rebooted to change the operation mode.
Menu Changes with Switch Operating Mode
Once the switch is configured for IP Routing (Layer 3
Switching), and rebooted, the Main Menu adds some
functions compared to the Layer 2 Only mode. These
functions are reflected in additional configuration menus, and
the addition of the Layer 3 IP Networking entry. All of the
console menus are listed, in order, in the Screen Hierarchy
below.
28 VH-2402-L3 Management Guide
> can be
9033691-01
Advertisement
Table of Contents
