Table of Contents
Advertisement
8R - 18
WIPERS/WASHERS
WIPER LINKAGE (Continued)
1 - NUT (5)
2 - WASHER (5)
(3) Remove the five nuts that secure the ventila-
tion housing to the dash panel and the underside of
the cowl top panel (Fig. 21).
(4) Pull the ventilation housing forward far enough
to disengage the housing from the studs on the dash
panel, then lower the housing until it rests on the
top of the engine.
(5) Disconnect the wiper motor pigtail wire connec-
tor from the vehicle wire harness connector.
(6) Remove the nut and washer that secures each
wiper pivot housing to the outside of the cowl top
panel (Fig. 22).
1 - NUT & WASHER (2)
2 - PIVOT (2)
3 - SCREW (2)
Fig. 21 Ventilation Housing
Fig. 22 Wiper Linkage Module Remove/Install
3 - CABIN FILTER HOUSING
4 - VENTILATION HOUSING
(7) Remove the two screws that secure the wiper
linkage module motor bracket to the flange on the
underside of the cowl top panel.
(8) Remove the wiper linkage module and wiper
motor from the underside of the cowl top panel as a
unit.
(9) Remove the wiper motor from the wiper link-
age module. (Refer to 8 - ELECTRICAL/WIPERS/
WASHERS/WIPER MOTOR - REMOVAL).
INSTALLATION
(1) Reinstall the wiper motor onto the wiper link-
age module. (Refer to 8 - ELECTRICAL/WIPERS/
4 - COWL TOP PANEL
5 - MOTOR BRACKET
VA
Advertisement
Table of Contents
