Table of Contents
Advertisement
8E - 4
ELECTRONIC CONTROL MODULES
ENGINE CONTROL MODULE (Continued)
1 - A/C PUSH BUTTON CONTROL
2 - ECM
3 - INSTRUMENT CLUSTER
4 - ABS/ASR CONTROLLER
5 - ANTI-THEFT CONTROLLER
6 - AIR BAG CONTROLLER
7 - IGNITION CYLINDER TRANSCEIVER RING
8 - GLOW PLUG RELAY
9 - INTAKE AIR TEMPERATURE SENSOR
10 - KICK DOWN SWITCH
11 - ACCELERATOR PEDAL SENSOR
REMOVAL
(1) Disconnect the negative battery cable.
(2) Disconnect the ECM harness connectors (5)
(Fig. 3).
(3) Grasp ECM and pull down firmly to release
ECM from the retaining bracket tensioning springs
(Fig. 3).
Fig. 2 ECM
12 - MASS AIR FLOW SENSOR
13 - CRANKSHAFT POSITION SENSOR
14 - OIL LEVEL, OIL TEMPERATURE AND OIL QUALITY SENSOR
15 - LOW FUEL PRESSURE SENSOR
16 - COOLANT TEMPERATURE SENSOR
17 - FUEL RAIL PRESSURE SENSOR
18 - CAMSHAFT POSITION SENSOR
19 - CHARGE AIR PRESSURE SENSOR
20 - FUEL TEMPERATURE SENSOR
21 - WATER IN FUEL SENSOR
INSTALLATION
NOTE: THE ECM MUST BE PROGRAMMED TO SUP-
PORT THE VEHICLE OPTIONS PACKAGE.
(1) Position the ECM into the guide of the retain-
ing bracket (Fig. 3).
(2) Carefully push the ECM in to the bracket until
the bracket tensioning springs engage (Fig. 3).
(3) Connect the ECM wiring harness connectors
(5) (Fig. 3).
(4) Connect negative battery cable.
VA
Advertisement
Table of Contents
