Table of Contents
Advertisement
VA
BRAKES - BASE (Continued)
Fig. 1 Bleed Hose Setup
1 - BLEED HOSE
2 - FLUID CONTAINER PARTIALLY FILLED WITH FLUID
HYDRAULIC/MECHANICAL
SPECIFICATIONS
SPECIFICATIONS - TORQUE CHART
DESCRIPTION
Brake Lines
Master Cylinder To Brake
Booster Nut
Brake Caliper Adapter
Rear
M12 X 1.5 Bolt
Brake Caliper Adapter
Rear
M14 X 1.5 Bolt
Brake Caliper Adapter
Front
Disc Brake Rotor Locking
Bolt
Front or Rear
Wear Indicator To Caliper
Bolt
Front or Rear
(4) Open up bleeder, then have a helper press
down the brake pedal. Once the pedal is down close
the bleeder. Repeat bleeding until fluid stream is
clear and free of bubbles. Then move to the next
wheel.
STANDARD PROCEDURE - PRESSURE
BLEEDING
Use Mopar brake fluid, or an equivalent quality
fluid meeting SAE and DOT 4 standards only. Use
fresh, clean fluid from a sealed container at all times.
Follow the manufacturers instructions carefully
when using pressure equipment. Do not exceed the
tank manufacturers pressure recommendations. Gen-
erally, a tank pressure of 15-20 psi is sufficient for
bleeding.
Fill the bleeder tank with recommended fluid and
purge air from the tank lines before bleeding.
Do not pressure bleed without a proper master cyl-
inder adapter. The wrong adapter can lead to leak-
age, or drawing air back into the system.
TORQUE SPECIFICATIONS
N·m
14
28
90
170
170
23
10
BRAKES - BASE 5 - 5
Ft. Lbs.
—
—
66
125
125
—
—
In. Lbs.
124
248
—
—
—
204
89
Advertisement
Table of Contents
